The Cast Iron V42 series valve bodies are being updated to new tooling. While the key dimensional characteristics will stay unchanged, you will notice new AQ Matic branding. The fit, form, and function of the parts will remain unaffected and the new valves will be fully interchangeable with the old. These changes are being made to update branding, reduce variation, and streamline the supply chain.… Read article...
The NXT Stager Control will be updated with a few new features and options as shown below. These changes will become available in June 2017.
A transformer accepting either 115V, 208V, or 240V 50/60Hz input voltages will be mounted inside the enclosure. This transformer will be pre-wired to the circuit board allowing the installer to simply run line voltage into a terminal strip within the enclosure.
The K52 Series Diaphragm & Seal Kits will be changed to remove the “Old” style rubber components. These “Old” components were used on valves made prior to 1998, most easily identified by blue bodies and caps. Since 1998, the K52 series valves have been black in color and use the “New” style internal components.… Read article...
Many people have been asking which type of diaphragm, seals and discs they should use with their AqMatic/AquaMatic valves, or need replacement parts for a valve they already have.
With a little bit of data we can determine what is the right kit to get.
I hope this helps.
Buna-N = Standard operation for most liquids and air.
FKM = For high temperatures.… Read article...
To determining what type of AquaMatic valve you have, or need, one must figure out if they have a Normally Open or Normally Closed valve. These are the base configuration of all AquaMatic valves. To understand what type of valve you need you must understand the operation of the valve.
AquaMatic valves are controlled by pressure. The two main types of pressure that are used are line pressure and control pressure.… Read article...